How to use the touch probe to find the center of a cylinder (F1)
How to use the touch probe to find the center of a cylinder (F1)
Use of the feeler to identify the center of a cylinder, as long as it is in (electrical) contact with the vacuum plane or with the clamps.
Related Articles
Pigreco ORIGINS How to create and use them
How to set and use the Origin (G54,....) in Pigreco.
How to use the Removable Vacuum Table (F1)
Complete procedure to set up the work on the removable vacuum table and the manual vice.
How to use Markers to create a special ring (F35)
Procedure for creating a ring with a particular solution using the Markers in F35
How to use the Caliper to read a dimension (F35)
Procedure for using the caliper to read a specific height of a point.
Use the Caliper to check the Axis alignment of the F35
Wizard for using the Caliper (required) to check the alignment of the F35 axes.